Friday, February 21, 2020

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 965

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 965



DTC Descriptors



DTC P018B



- Fuel Pressure Sensor Performance



DTC P018C



- Fuel Pressure Sensor Circuit Low Voltage



DTC P018D



- Fuel Pressure Sensor Circuit High Voltage



Diagnostic Fault Information



Circuit/System Description



The fuel pressure sensor is located on the fuel line. The fuel pressure sensor monitors the fuel pressure in the fuel line. The fuel pump control



module monitors the voltage signal from the fuel pressure sensor.



Conditions for Running the DTC



* The engine is running.



* DTC P018C, P018D, P0231, P0232, P023F, P064A, P1255 or P06A6 are not active.



* DTC P0641 has not failed this ignition cycle.



* Fuel pump control is enabled and the fuel pump control state is normal.



* The engine has been running for at least 5 seconds.



Conditions for Setting the DTC



The fuel pump control module does not detect a change in the fuel pressure of at least 30 kPa (4.4 psi) when the fuel pump is operating. The fuel



pressure sensor performance diagnostic provides a means to detect fuel pressure sensor output that is stuck within the normal operating range of the



sensor.



Action Taken When the DTC Sets



DTC P018B, P018C and P018D are Type A DTCs.



Conditions for Clearing the DTC



DTC P018B, P018C and P018D are Type A DTCs.



Diagnostic Aids



Using the Failure Records data may help locate an intermittent condition. If you cannot duplicate the DTC, the information in the Failure Records



can help determine how many miles since the DTC set. The Fail Counter and Pass Counter can help determine how many ignition cycles that the



diagnostic test reported a pass and/or a fail.



Reference Information



Schematic Reference



Engine Controls Schematics (LAU) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)Engine Controls Schematics



(LF1) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



Fuel System Description (LF1) (See: Powertrain Management/Fuel Delivery and Air Induction/Description and Operation)Fuel System



Description (LAU or LY7) (See: Powertrain Management/Fuel Delivery and Air Induction/Description and Operation)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General