2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 1579
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
Control Module References (See: Testing and Inspection/Programming and Relearning) for PIM replacement, setup, and programming.
P1B03
DTC P1B03 or P1B04
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC P1B03
- Drive Motor 1 Position Sensor Circuit Loss of Tracking
DTC P1B04
- Drive Motor 2 Position Sensor Circuit Loss of Tracking
Diagnostic Fault Information
Circuit/System Description
The drive motor position sensor is monitored by the motor control module (MCM). The MCM monitors the angular position, speed and direction of
the drive motor generator based upon the signals of the resolver-type position sensor. The position sensor, or resolver, contains a drive coil, two
driven coils and an irregular shaped metallic rotor. The metallic rotor is mechanically attached to the shaft of the drive motor generator. At ignition
ON, the MCM outputs a 7 volt ac, 10 kHz excitation signal to the drive coil. The drive coil excitation signal creates a magnetic field surrounding
the two driven coils and the irregular shaped rotor. The MCM then monitors the two driven coil circuits for a return signal. The position of the
irregular shaped metallic rotor causes the magnetically-induced return signals of the driven coils to vary in size and shape. A comparison of the two
driven coil signals allows the MCM to determine the exact position, speed and direction of the drive motor generator.
Conditions for Running the DTC
