2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 1723
瀚慖f the DTC resets after programming or if the PIM already contains the latest software version, replace the PIM.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
Control Module References (See: Testing and Inspection/Programming and Relearning) for PIM replacement, setup, and programming.
2ML70 - Automatic Transmission
DTC P0601-P0606, P060B, or P062F
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC P0601
- Transmission Control Module (TCM) Read Only Memory (ROM)
DTC P0602
- Transmission Control Module (TCM) Not Programmed
DTC P0603
- Transmission Control Module (TCM) Long Term Memory Reset
DTC P0604
- Transmission Control Module (TCM) Random Access Memory (RAM)
DTC P0606
- Transmission Control Module (TCM) Internal Performance
DTC P060B
- Control Module Analog to Digital Performance
DTC P062F
- Transmission Control Module (TCM) Long Term Memory Performance
Circuit/System Description
This is an internal fault detection of the transmission control module. This fault is handled inside the transmission control module and no external
circuits are involved. The transmission control module is part of the control solenoid valve assembly, and is not serviced separately.
Conditions for Running the DTC
* The control solenoid valve assembly runs the program to detect an internal fault when the key is ON or the engine is running.
* Ignition voltage is 8-18 V.
Conditions for Setting the DTC
The control solenoid valve assembly has detected an internal malfunction.
Action Taken When the DTC Sets
* DTCs P0601, P0602, P0603, P0604, P0606, P060B and P062F are Type A DTCs.
* The transmission control module shifts to a default gear and turns OFF.
Conditions for Clearing the DTC
DTCs P0601, P0602, P0603, P0604, P0606, P060B and P062F are Type A DTCs.
