2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 749
* Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM replacement, programming and setup
B3951
DTC B3950 or B3951
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC B3950 02
- Left Rear Turn Signal Circuit Short to Ground
DTC B3951 02
- Right Rear Turn Signal Circuit Short to Ground
Diagnostic Fault Information
Circuit/System Description
Ground is applied at all times to the turn signal/multifunction switch. The turn signal lamps may only be activated with the ignition switch in the
ON or START position. When the turn signal/multifunction switch is placed in either the TURN RIGHT or TURN LEFT position, ground is
applied to the body control module through either the right turn or left turn signal switch signal circuit. The BCM then applies a pulsating voltage to
the front and rear turn signal lamps through there respective voltage supply circuits. When a turn signal request is received by the BCM, a serial
data message is sent to the instrument cluster requesting the respective turn signal indicator be pulsed ON and OFF.
Conditions for Running the DTC
The appropriate turn signal is active
Conditions for Setting the DTC
The BCM detects a short to ground on the rear turn signal control circuit
Action Taken When the DTC Sets
The appropriate rear turn signal will be inoperative.
Conditions for Clearing the DTC
* The DTC will be current for as long as the fault is present.
* When the fault is no longer present, the DTC will be a history DTC.
* A history DTC will clear after 50 ignition cycles.
Reference Information
Schematic Reference
Exterior Lights Schematics (See: Diagrams/Electrical Diagrams/Lighting and Horns/System Diagram/Exterior Lights Schematics)
Connector End View Reference
