2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 927
* The ignition voltage is 8.6 volts or greater.
* Brake torque is not active.
* The torque signal is valid.
* The throttle position signal is valid.
P06AD
* No DTCs P06AD, P0716, P0717, P0722, or P0723.
* The engine speed is 400 RPM or greater for 5 seconds.
* The ignition voltage is 8.6 volts or greater.
P06AE
* The engine speed is 400 RPM or greater for 5 seconds.
* The ignition voltage is 8.6 volts or greater.
* DTC P06AE has not set this ignition cycle.
Conditions for Setting the DTC
P06AC
* The difference between the transmission fluid temperature (TFT) and TCM power up temperature is greater than 20-50掳C (36-90掳F),
depending on the average of the TFT, TCM substrate, and TCM power up temperatures.
* The difference between the TCM substrate temperature and TCM power up temperature is greater than 8-10掳C (14-18掳F) depending on the
average of the TFT, TCM substrate, and TCM power up temperatures.
* The above conditions have to be met for 5 minutes within a 6 minute period.
P06AD
The TCM power up temperature is -59掳C (-74掳F) or less for 1 minute.
P06AE
The TCM power up temperature is 165掳C (329掳F) or greater for 1 minute.
Action Taken When the DTC Sets
* DTC P06AC, P06AD, P06AE are Type B DTCs.
* The TCM defaults the TCM power up temperature to the TCM substrate temperature.
Conditions for Clearing the DTC
DTC P06AC, P06AD, P06AE are Type B DTCs.
Reference Information
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)
Description and Operation
* Transmission General Description (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and
Operation/6T70/6T75 - Automatic Transmission/Transmission General Description)
* Electronic Component Description (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and
Operation/6T70/6T75 - Automatic Transmission/Electronic Component Description) for control solenoid valve assembly
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code
(DTC) Type Definitions)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
1. Engine idling at normal operating temperature, verify the scan tool TCM Power up Temperature parameter is between -59 and +165掳C (-74
and +329掳F).
2. Operate the vehicle at 64 km/h (40 mph) for 10 minutes. Monitor the TCM Temperature, TCM Power up Temperature, and the Trans. Fluid
Temp. parameters with a scan tool. The TCM Temperature and the Trans. Fluid Temp. parameters should be within 20掳C (36掳F) of each
other, and the TCM Temperature and TCM Power up Temperature parameters should be within 10掳C (18掳F) of each other.
瀚慖f the TCM Temperature and TCM Power up Temperature parameters are not within 10掳C (18掳F), or the TCM Power up Temperature
and Trans. Fluid Temp. parameters are not within 20掳C (36掳F), replace the control solenoid valve assembly.
