2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 401
B0954 06, B0955 06, B0956 06, or B0957 06
The parking assist control module has detected the voltage at the sensor circuit is less than 0.5 V.
B0954 08, B0955 08, B0956 08, or B0957 08
The parking assist control module has received an invalid signal.
B0954 21, B0955 21, B0956 21, or B0957 21
The object sensor determines no change in the position of an object while the vehicle is in motion.
B0954 3A, B0955 3A, B0956 3A, or B0957 3A
The parking assist control module determines the wrong sensor type is installed.
Action Taken When the DTC Sets
* The parking assist is disabled.
* The driver information center displays SERVICE PARK ASSIST.
Conditions for Clearing the DTC
The condition for setting the DTC is no longer present.
Reference Information
Schematic Reference
Object Detection Schematics (See: Accessories and Optional Equipment/Collision Avoidance and Parking Assist Systems/Diagrams/Electrical
Diagrams)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)
Description and Operation
Object Detection Description and Operation (UVC) (See: Accessories and Optional Equipment/Collision Avoidance and Parking Assist
Systems/Description and Operation/Object Detection (UVC))Object Detection Description and Operation (UD5) (See: Accessories and Optional
Equipment/Collision Avoidance and Parking Assist Systems/Description and Operation/Object Detection Description and Operation (UD5))
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
1. Verify that DTC B1405 is not present.
瀚慖f DTC is present, refer to DTC B1405 (See: B Code Charts/B1405/Object Detection).
2. Verify that DTC B0954 01, B0955 01, B0956 01 or B0957 01 is not present.
瀚慖f DTC is present, check the appropriate sensor for contamination with mud, ice or snow. If no contamination is diagnosed, refer to
Circuit/System Testing.
3. Verify that DTC B0954 21, B0955 21, B0956 21 or B0957 21 is not present.
瀚慖f DTC is present, check the respective sensor for contamination by mud, ice or snow. If no contamination is diagnosed, replace the
