2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 410
Conditions for Setting the DTC
B0958 01, B0959 01, B0960 01, or B0961 01
The parking assist control module has detected the voltage at the sensor circuit is greater than 11.5 V or the object sensor is not grounded.
B0958 06, B0959 06, B0960 06, or B0961 06
The parking assist control module has detected the voltage at the sensor circuit less than 0.5 V.
B0958 08, B0959 08, B0960 08, or B0961 08
The parking assist control module has received an invalid signal.
B0958 21, B0959 21, B0960 21, or B0961 21
The object sensor determines no change in the position of an object while the vehicle is in motion.
B0958 3A, B0959 3A, B0960 3A, or B0961 3A
The parking assist control module determines the wrong sensor type is installed.
Action Taken When the DTC Sets
^ The parking assist is disabled.
^ The driver information center displays SERVICE PARK ASSIST.
Conditions for Clearing the DTC
The condition for setting the DTC is no longer present.
Diagnostic Aids
For symptom byte 21 the module only runs diagnostic when the vehicle is driven greater than 40 km/h (25 MPH). Therefore, even with clean
sensor with no obstruction (i.e snow or ice melted off) drive the vehicle greater than 40 km/h (25 MPH).
The following is a list of reasons this failure type byte 21 might have set:
^ One or more of the sensors may be blocked by snow, mud, ice or debris. This might happen after going through a car wash in cold weather.
^ Silicone insulator surrounding sensor maybe missing, cut or twisted.
^ Improperly installed sensor, sensor maybe be crooked due to a tight wire harness.
^ One or more of the sensors may be scratched or the paint maybe chipped.
^ Excessive paint thickness on a sensor may cause an excessive sensor ring time. When replacing or refinishing a sensor, do not apply an
excessive amount of paint or clear coat.
Reference Information
Schematic Reference
Object Detection Schematics (See: Accessories and Optional Equipment/Collision Avoidance and Parking Assist Systems/Diagrams/Electrical
Diagrams)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)
Description and Operation
Object Detection Description and Operation (UVC) (See: Accessories and Optional Equipment/Collision Avoidance and Parking Assist
Systems/Description and Operation/Object Detection (UVC))Object Detection Description and Operation (UD5) (See: Accessories and Optional
Equipment/Collision Avoidance and Parking Assist Systems/Description and Operation/Object Detection Description and Operation (UD5))
Electrical Information Reference
^ Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
^ Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
^ Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
^ Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
