2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 417
4. Command the Park Assist Switch LED output control OFF with the scan tool. Test for less than 0.3 V between the ignition circuit terminal 3
and the signal circuit terminal 6.
瀚慖f greater than the specified value, test the signal circuit for a short to ground. If all circuits test normal, replace the K41 parking assist
control module.
5. If all circuits test normal, replace the S48E multi-function switch module - center console.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Accessory Switch Replacement (See: Instrument Panel, Gauges and Warning Indicators/Service and Repair)
* Control Module References (See: Testing and Inspection/Programming and Relearning) for parking assist control module replacement,
programming and setup
B0968
DTC B0967 or B0968
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC B0967 02
- Parking Aid On/Off Switch Circuit Short to Ground
DTC B0968 01
- Parking Aid On/Off Switch Indicator Circuit Short to Battery
DTC B0968 06
- Parking Aid On/Off Switch Indicator Circuit Low Voltage/Open
Diagnostic Fault Information
Circuit/System Description
The parking assist can be activated/deactivated by pressing the parking assist switch. By engaging the reverse gear the parking assist can also be
activated. By subsequently pressing the parking assist switch the parking assist can be disabled again.
The indicator in the parking assist switch shows the status of the parking assist. If the lamp is ON, the parking assist is activated.
Conditions for Running the DTC
* Ignition ON
* The parking assist is activated. The activation takes place by putting in the reverse gear or by pressing the parking assist switch.
Conditions for Setting the DTC
B0967 02
The parking assist control module has detected a short to ground.
