Friday, December 13, 2019

2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Technical Service Bulletin # 05-06-01-034L Date: 100723

2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Technical Service Bulletin # 05-06-01-034L Date: 100723



Engine - Oil Leaks From Rear Cover



TECHNICAL



Bulletin No.: 05-06-01-034L



Date: July 23, 2010



Subject: 5.3L, 5.7L, 6.0L, 6.2L, 7.0L - Engine Oil Leak at Rear Cover Assembly Area (Engine Block Porosity RTV Repair Procedure)



Models:



2004-2007 Buick Rainier



2008-2009 Buick LaCrosse Super, Allure Super (Canada Only)



2005-2011 Cadillac CTS-V



2007-2011 Cadillac Escalade, Escalade ESV, Escalade EXT



2003-2009 Chevrolet TrailBlazer



2003-2011 Chevrolet Corvette



2004-2006 Chevrolet SSR



2005-2011 Chevrolet Silverado, Silverado SS



2006-2007 Chevrolet Monte Carlo SS



2006-2009 Chevrolet TrailBlazer SS, Impala SS



2007-2011 Chevrolet Avalanche, Suburban, Tahoe



2009-2010 Chevrolet Colorado Pickup



2010-2011Chevrolet Camaro



2003-2009 GMC Envoy



2003-2011 GMC Sierra



2004-2005 GMC Envoy XUV



2007-2011 GMC Yukon XL, Yukon Denali, Yukon XL Denali



2009-2011 GMC Canyon



2004-2006 Pontiac GTO



2005-2008 Pontiac Grand Prix GXP



2008-2009 Pontiac G8 GT



2009 Pontiac G8 GXP



2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 302



2005-2009 Saab 9-7X 5.3i



2008-2009 Saab 9-7X Aero



2003-2010 HUMMER H2



2006-2010 HUMMER H3



with 5.3L, 5.7L, 6.0L, 6.2L, 7.0L VORTEC(TM) GEN III or GEN IV V8 Engine (All Aluminum Block) (RPOs L33, LC9, LH6, LH8, LH9, LM4,



LS4, LS1, LS6, L76, L77, LFA, LZ1, LS2, L92, L94, L99, L9H, LS3, LS9, LSA, LS7)



Supercede:



This bulletin is being revised to add the 2011 model year and update the Warranty Information for the Corvette. Please discard Corporate Bulletin



Number 05-06-01-034K (Section 06 - Engine/Propulsion System).



Condition



Some customers may comment on an engine oil leak.



Cause



Upon initial diagnosis, it may be determined that the leak is coming from the rear cover gasket. This condition may be caused by engine block



porosity on the sealing surface. This issue pertains to aluminum block applications only.



Correction



Follow the steps for Oil Leak Diagnosis in SI to determine the source of the leak. If the leak has been diagnosed as coming from the engine rear



cover assembly, refer to Engine Rear Cover Replacement in SI and remove the engine rear cover assembly. Inspect the engine block and engine



rear cover for porosity on the mating surfaces.



- If porosity is found on the engine rear cover (see illustration below), replace the engine rear cover assembly, GM P/N 12633579.



- If porosity is found on the engine block, use the following procedure to apply RTV to repair the engine block porosity.



The porosity issue is in the gasket sealing surface at the top of the cover, near the high pressure oil crossover port. Refer to the picture below. The



oil leaks by the gasket and runs down the side of the cover, and may appear to be a leak at the t-joint area of the cover. The fix is to replace the



cover with GM P/N 12633579. Also, if porosity is found anywhere on the sealing surface of the engine block, use the following procedure to apply



RTV to repair the engine block porosity. Refer to the illustration below.



Important



Clean any residual oil from the block and cover before applying the sealant in the next step.



1. Wipe a small amount of RTV, P/N 12378521 (in Canada, use P/N 88901148), onto the surface using a plastic scraper to fill the porosity.



2. Remove any excess RTV material, especially from inside the high pressure oil passage. Refer to #1 in the above illustration.



3. The joint may be closed immediately after applying the RTV. Total joint time after the RTV has been applied must be under 20 minutes.



Important



Refer to Engine Rear Cover Replacement in SI and follow the tightening specifications and sequence.



4. Reinstall the engine rear cover using a new gasket and a new crankshaft rear main seal. Refer to Engine Rear Cover Replacement in SI.



Parts Information



2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 303



Important



For Saab (U.S.) only, use P/N 88861206 - Engine Oil Dye (U.S.) or equivalent.



Warranty Information (excluding Saab U.S. Models)



For vehicles repaired under warranty, use:



Warranty Information (Saab U.S. Models)



For vehicles repaired under warranty, use the table.



2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 304