2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 781
瀚慖f DTC is set, perform the Electronic Parking Brake Control Module Programming and Setup (See: Brakes and Traction Control/Parking
Brake System/Parking Brake Control Module/Testing and Inspection).
2. With a scan tool , perform the Parking Brake Actuator DTC Reset procedure. Verify DTC C056D is not set.
瀚慖f the DTC is set, replace the K83 Parking Brake Control Module.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
Control Module References (See: Testing and Inspection/Programming and Relearning) for parking brake control module replacement, setup, and
programming.
Data Communications
DTC C056D
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC C056D XX
- Electronic Control Unit Hardware
Circuit/System Description
The internal fault detection is handled inside the control module. The symptom byte listed in the DTC Descriptor is for engineering reference only.
No external circuit diagnosis is involved.
Conditions for Running the DTC
The module runs the program to detect an internal fault when power up is commanded. The only requirements are voltage and ground. This
program runs even if the voltage is out of the valid operating range.
Conditions for Setting the DTC
The module has detected an internal malfunction.
Action Taken When the DTC Sets
The module refuses all additional inputs.
Conditions for Clearing the DTC
* A current DTC clears when the malfunction is no longer present.
* A history DTC clears when the module ignition cycle counter reaches the reset threshold of 50, without a repeat of the malfunction.
Diagnostic Aids
* This DTC may be stored as a history DTC without affecting the operation of the module.
* If stored only as a history DTC and not retrieved as a current DTC, do not replace the module.
* If this DTC is retrieved as both a current and history DTC, replace the module that set the DTC.
Circuit/System Verification
Verify that DTC C056D is not set.
If the DTC is set, program the control module. If the DTC resets, replace the control module that set the DTC.
