2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 568
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
Ignition ON, observe the scan tool Exterior Driver Door Handle Proximity Sensor parameter while pressing and releasing the driver door handle
lock switch. The value should change between Active and Inactive as the switch is pressed and released.
Circuit/System Testing
1. Ignition OFF, disconnect the harness connector at the A24D Door Handle Assembly-Driver.
2. Ignition ON, verify the scan tool Exterior Driver Door Handle Proximity Sensor parameter is Inactive.
瀚慖f not the specified value, test the signal circuit terminal 3 for a short to ground. If the circuit tests normal, replace the K84 Keyless Entry
Control Module.
3. If all circuits test normal, test or replace the A24D Door Handle Assembly-Driver.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Front Side Door Outside Handle Replacement (See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Front Door Handle/Front
Door Exterior Handle/Service and Repair)
* Control Module References (See: Testing and Inspection/Programming and Relearning) for the keyless entry control module replacement,
setup and programming
B2530
DTC B2530
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC B2530 02
- Front Fog Lamps Control Circuit Short to Ground
Diagnostic Fault Information
Circuit/System Description
The front fog lamp relay is supplied with battery voltage at all times. The front fog lamp switch signal circuit is grounded momentarily by pressing
the front fog lamp switch. The body control module (BCM) energizes the front fog lamp relay by applying ground to the front fog lamp relay
control circuit. When the front fog lamp relay is energized, the relay switch contacts close and battery voltage is applied through the front fog lamp
fuse to the front fog lamp supply voltage circuit which illuminates the front fog lamps.
Conditions for Running the DTC
Front fog lamps activated
Conditions for Setting the DTC
