2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 586
Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC B2625 02
- Display Dimming Pulse Width Modulation Output Circuit Short to Ground
Diagnostic Fault Information
Circuit/System Description
The dimmer switch is used to increase and decrease the brightness of the interior backlighting components. The body control module (BCM)
supplies a reference voltage to the backlight dimmer switch, which is part of the headlamp switch. When the dimmer switch is placed in a desired
brightness position, the dimmed voltage setting is applied through the dimmer switch and the dimmer switch signal circuit to the BCM. The BCM
interprets this voltage signal, then applies a pulse width modulated (PWM) voltage through the backlight lamp control circuit and the LED dimming
control circuit illuminating the components to the requested level.
Conditions for Running the DTC
The ignition is ON.
Conditions for Setting the DTC
The BCM detects a short to ground in the LED dimming control circuit.
Actions Taken When the DTC Sets
The BCM will not attempt to illuminate the LED indicator lamps when a short circuit to ground is detected.
Conditions for Clearing the DTC
* The condition responsible for setting the DTC no longer exists.
* A history DTC will clear once 100 consecutive malfunction-free ignition cycles have occurred.
Reference Information
Schematic Reference
Interior Lights Dimming Schematics (See: Diagrams/Electrical Diagrams/Lighting and Horns/System Diagram/Interior Lights Dimming
Schematics)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)
Description and Operation
Interior Lighting Systems Description and Operation (See: Lighting and Horns/Description and Operation/Interior Lighting Systems)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
