2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 483
* When the fault is no longer present, the DTC will be a history DTC.
* A history DTC will clear after 50 ignition cycles.
Reference Information
Schematic Reference
Door Lock/Indicator Schematics (See: Body and Frame/Locks/Diagrams/Electrical Diagrams/Door Lock/Indicator Schematics)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)
Description and Operation
Power Door Locks Description and Operation (See: Body and Frame/Locks/Power Locks/Description and Operation)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
1. Ignition ON, observe the scan tool Exterior Left Rear Door Handle Switch parameter while pulling and releasing the B27LR door handle
switch - left rear exterior. The parameter should change between Active and Inactive.
瀚慖f the value is always Inactive or always Active, refer to Left rear Exterior Door Handle Inoperative.
2. Ignition ON, observe the scan tool Exterior Right Rear Door Handle Switch parameter while pulling and releasing the B27RR door handle
switch - right rear exterior. The parameter should change between Active and Inactive.
瀚慖f the value is always Inactive or always Active, refer to Right Rear Exterior Door Handle Inoperative.
Circuit/System Testing
Left Rear Exterior Door Handle Inoperative
1. Ignition OFF, disconnect the harness connector at the B27LR door handle switch-left rear exterior.
2. Ignition ON, verify the scan tool Exterior Left Rear Door Handle Switch parameter is Inactive:
瀚慖f not the specified value, test the signal circuit terminal 2 for a short to ground. If the circuit tests normal, replace the K84 keyless entry
control module.
3. Install a 3 A fused jumper wire between the signal circuit terminal 2 and ground. Verify the scan tool Exterior Left Rear Door Handle Switch
parameter is Active.
瀚慖f not the specified value, test the signal circuit terminal 2 for an open/high resistance. If the circuit tests normal, replace the K84 keyless
entry control module.
4. If all circuits test normal, test or replace the B27LR door handle switch-left rear exterior.
Right Rear Exterior Door Handle Inoperative
1. Ignition OFF, disconnect the harness connector at the B27RR door handle switch-right rear exterior.
2. Ignition ON, verify the scan tool Exterior Right Rear Door Handle Switch parameter is Inactive:
瀚慖f not the specified value, test the signal circuit terminal 2 for a short to ground. If the circuit tests normal, replace the K84 keyless entry
control module.
3. Install a 3 A fused jumper wire between the signal circuit terminal 2 and ground. Verify the scan tool Exterior Right Rear Door Handle
Switch parameter is Active.
瀚慖f not the specified value, test the signal circuit terminal 2 for an open/high resistance. If the circuit tests normal, replace the K84 keyless
