2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 691
* A history DTC will clear after 40 malfunction-free ignition cycles have occurred.
Reference Information
Schematic Reference
Cruise Control Schematics (See: Cruise Control/Diagrams/Electrical Diagrams)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)
Description and Operation
Cruise Control Description and Operation (See: Cruise Control/Description and Operation)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning)for scan tool information
Circuit/System Verification
Engine ON, while rotating the steering wheel to both steering stops, observe the scan tool Cruise Control Switch parameter while pressing each of
the cruise control switches. The parameter should toggle between On, Off, Resume, Set, and Cancel as the applicable switch is pressed.
Circuit/System Testing
1. Ignition OFF, disconnect the harness connector at the S70L steering wheel control switch-left.
2. Ignition ON, test for B+ between the B+ circuit terminal 1 and ground.
瀚慖f less than the specified value, test the circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the K9
BCM.
3. Test for B+ between the B+ circuit terminal 1 and the signal circuit terminal 2.
瀚慖f less than the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace
the K9 BCM.
4. Ignition OFF, disconnect the X1 harness connector at the K9 BCM.
5. Test for infinite resistance between the signal circuit terminal 3 and ground.
瀚慖f less than the specified value, test the signal circuit for a short to ground.
6. If all circuits test normal, test or replace the S70L steering wheel control switch-left.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Cruise Control Switch Replacement (See: Cruise Control/Cruise Control Switch/Service and Repair)
* Control Module References (See: Testing and Inspection/Programming and Relearning)for BCM replacement, setup, and programming
B3797
DTC B3797
Diagnostic Instructions
* Perform the prior to Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic
Overview/Diagnostic System Check - Vehicle) using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
