2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 674
2. Test for infinite resistance between the signal terminal 3 and the ground terminal 1 with the switch in the open position.
瀚慖f not the specified value, replace the S1 adjustable pedal control switch.
3. Test for less than 2 ohm between the signal terminal 3 and the ground terminal 1 with the switch in the closed position.
瀚慖f greater than the specified range, replace the S1 adjustable pedal control switch.
4. Test for infinite resistance between the signal terminal 5 and the ground terminal 1 with the switch in the open position.
瀚慖f not the specified value, replace the S1 adjustable pedal control switch.
5. Test for less than 2 ohm between the signal terminal 5 and the ground terminal 1 with the switch in the closed position.
瀚慖f greater than the specified range, replace the S1 adjustable pedal control switch.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Brake and Accelerator Pedal Adjuster Switch Replacement (See: Accessories and Optional Equipment/Pedal Positioning System/Pedal
Positioning Switch/Service and Repair)
* Control Module References (See: Testing and Inspection/Programming and Relearning) for memory seat control module replacement, setup,
and programming
B3605
DTC B3604 or B3605
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC B3604 02
- Adjustable Pedal Forward Switch Circuit Short to Ground
DTC B3605 02
- Adjustable Pedal Rearward Switch Circuit Short to Ground
Diagnostic Fault Information
Circuit/System Description
Ground is supplied at all times to the adjustable pedal switch. When the pedals switch is pressed, a 5 V reference voltage is applied through the
switch contacts and the switch signal circuit to the memory seat control module. The memory seat control module then commands the adjustable
pedals motor to move in response to the switch signal.
Conditions for Running the DTC
The memory seat control module must be powered.
Conditions for Setting the DTC
The forward and rearward switch signal circuits are active at the same time.
