2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 349
DTC Descriptor
DTC B1008 00
- Calibration Data Not Programmed
Circuit/System Description
When replacing a remote control door lock receiver (RCDLR), the service replacement part is shipped with no installed software. Before the new
RCDLR is operational, a software calibration is required to be downloaded using the SPS terminal. Failure to download this software calibration
will result in the setting of DTC B1008.
Conditions for Running the DTC
This DTC runs continuously
Conditions for Setting the DTC
The RCDLR has no calibration loaded.
Action Taken When the DTC Sets
All functions handled by the RCDLR are inoperative
Conditions for Clearing the DTC
A current DTC will clear when software calibrations are installed.
Reference Information
Schematic Reference
Remote Function Schematics (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Keyless Entry/Keyless Entry
Transmitter/Diagrams/Electrical Diagrams)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
Keyless Entry System Description and Operation (Without Accessory 2 Way Remote) (See: Accessories and Optional Equipment/Antitheft and
Alarm Systems/Keyless Entry/Description and Operation/Keyless Entry System Description and Operation (Without Accessory 2 Way Remote)
)Keyless Entry System Description and Operation (With Accessory 2 Way Remote) (See: Accessories and Optional Equipment/Antitheft and
Alarm Systems/Keyless Entry/Description and Operation/Keyless Entry System Description and Operation (With Accessory 2 Way Remote))
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
Perform the RCDLR Programming and Setup procedure. Refer to Remote Control Door Lock Receiver Programming and Setup (See: Accessories
and Optional Equipment/Antitheft and Alarm Systems/Keyless Entry/Keyless Entry Receiver/Testing and Inspection).
If the DTC resets, replace the RCDLR.
Repair Instructions
Important: This vehicle may be equipped with the 2 Way Advanced Remote Start System. Vehicle equipped with the 2 Way Advanced
Remote Start System can be identified by an LCD screen on the keyless entry transmitter or a yellow label on the RCDLR. When servicing
the 2 Way Advanced Remote Start System, ensure that the correct parts are installed during replacement. Service parts for the 2 Way
Advanced Remote Start System can be found in the Accessory section of the parts manual.
