2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 487
DTC B1740 01
- Seat Front Down Switch Circuit Short to Battery
DTC B1745 01
- Seat Rear Up Switch Circuit Short to Battery
DTC B1750 01
- Seat Rear Down Switch Circuit Short to Battery
DTC B1755 01
- Seat Assembly Forward Switch Circuit Short to Battery
DTC B1760 01
- Seat Assembly Rearward Switch Circuit Short to Battery
DTC B1815 01
- Seat Recline Forward Switch Circuit Short to Battery
DTC B1820 01
- Seat Recline Rearward Switch Circuit Short to Battery
Diagnostic Fault Information
Circuit Description
When the power seat switches are pressed, they send a 12-volt signal through the switch signal circuits to the memory seat module (MSM). The
MSM then commands the driver seat motors to move in response to the switch signals.
Conditions for Running the DTC
The memory seat module must be powered.
Conditions for Setting the DTC
* If a seat switch circuit is active in one direction and the switch for the opposite direction is pressed, this DTC will set.
* Multiple DTCs will set if one of the switch signal circuits is shorted to voltage.
Action Taken When the DTC Sets
* A motor output driven in response to a switch considered failed, is deactivated for both directions.
* All memory recall commands are ignored.
* The MSM will respond to any other switch signal that has not set a DTC.
Conditions for Clearing the DTC
* The current DTC will clear and set the code to history, 3 seconds after the fault is no longer present and the ignition is cycled OFF then back
