2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 721
* The DTC will be current for as long as the fault is present.
* When the fault is no longer present, the DTC will be a history DTC.
* A history DTC will clear after 40 ignition cycles.
Reference Information
Schematic Reference
Trailer Connector/Provision Schematics (See: Diagrams/Electrical Diagrams/Starting and Charging/Power and Ground Distribution/System
Diagram/Trailer Connector/Provision Schematics)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)
Description and Operation
Exterior Lighting Systems Description and Operation (See: Lighting and Horns/Description and Operation/Exterior Lighting Systems)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
Ignition ON, observe the function of the left trailer turn signal lamp and the right trailer turn signal lamp while commanding the Left Trailer Turn
Signal Lamp and the Right Trailer Turn Signal Lamp ON and OFF with a scan tool. The left trailer turn signal lamp and the right trailer turn signal
lamp should turn ON and OFF while changing between the commanded states.
Circuit/System Testing
1. Ignition OFF, disconnect the X1 harness connector at the K68 trailer lighting control module.
2. Test for infinite resistance between the control circuit terminal listed below and ground:
* Right trailer turn signal lamp control terminal 2
* Left trailer turn signal lamp control terminal 17
瀚慖f less than the specified value, test the control circuit for a short to ground. If the circuit tests normal, replace the X88 trailer connector.
3. Test for less than 1 ohm between the control circuit terminals listed below:
* Control terminal 2 at the K68 trailer lighting control module and control terminal 4 at the X88 trailer connector.
* Control terminal 17 at the K68 trailer lighting control module and control terminal 1 at the X88 trailer connector.
瀚慖f greater than the specified range, test the control circuit for a short to voltage or an open/high resistance.
4. If all the circuits test normal, replace the K68 trailer lighting control module.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
Control Module References (See: Testing and Inspection/Programming and Relearning) for trailer brake control module replacement,
programming and setup
Without U4G
DTC B3887 or B3888 (Without U4G)
Diagnostic Instructions
