2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 694
Action Taken When the DTC Sets
Washer operation is suspended.
Conditions for Clearing the DTC
* A current DTC clears when the diagnostic runs and passes.
* A history DTC will clear after 50 consecutive ignition cycles without a fault present.
Diagnostic Aids
The headlamp wash feature shall only be allowed to be activated if the low or high beam headlamps are active too.
Reference Information
Schematic Reference
Wiper/Washer Schematics (See: Wiper and Washer Systems/Diagrams/Electrical Diagrams)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)
Description and Operation
Wiper/Washer System Description and Operation (See: Wiper and Washer Systems/Description and Operation)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning)for diagnostic tester information
Circuit/System Verification
Operate the headlamp washer using the S80 Window Wiper/Washer Switch. Verify the G16 Headlamp Washer Fluid Pump activates. The low or
high beam headlamps are ON.
Circuit/System Testing
1. Ignition OFF, disconnect the KR2 Headlamp Washer Fluid Pump Relay.
2. Test for less than 5 ohm between the ground circuit terminal 85 and ground
瀚慖f greater than the specified range, test the ground circuit for an open/high resistance
3. Connect a test lamp between the control circuit terminal 86 and ground.
4. Ignition ON, command the headlamp washer ON and OFF using the wiper switch. The test lamp should turn ON and OFF when changing
between the commanded states.
瀚慖f the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, test or replace the K9 Body Control
Module.
瀚慖f the test lamp is always OFF, test for a short to ground or an open/high resistance on the control circuit. If the circuit tests normal, test or
replace the K9 Body Control Module.
5. If all circuits test normal, test or replace the KR2 Headlamp Washer Fluid Pump Relay.
Component Testing
Relay Test
1. Ignition OFF, connect the KR2 Headlamp Washer Fluid Pump Relay.
2. Test for 60-200 ohm between terminals 85 and 86.
瀚慖f the resistance is not within the specified range, replace the relay.
